My 7004T, with attached 6004U expansion unit keeps rebooting. I haven’t identified a causal action yet, it started this behaviour when I tried to install Twonky so I removed that immediately. It was OK for a couple of days but has started doing it again today. I was moving files from one unit to the other at the time.
Where should I start looking for logs of the issue or known causes please?
TIA as always.
Go to System Information → Dr. ASUSTOR → System Log, especially the entries immediately before each reboot.
Thank you Damian.
I have the results. As far as I can see the only thing it flags as a problem is “[Certificate Manager] Authentication for lpnas7004t.myasustor.com failed.”
The text file is attached.
All I can eliminate so far is that I have removed the 6004U expansion unit but the NAS 7004T still reboots at (apparent) random.
Thanks for your help.
Here is my advice:
Do not shut down or restart the NAS until synchronization has fully completed.
Check the current progress in Storage Manager → Volume 1.
Leave the NAS running for several days if necessary.
Check the power supply and power strip, and ideally use a compatible USB UPS.
Check and reconnect the USB cable connected to the AS6004U.
Run a complete SMART test on each internal drive after synchronization has finished.
Do not run migrations, repeated IronWolf tests, or large file transfers simultaneously.
If the NAS continues to restart by itself, open a support ticket with ASUSTOR. The logs may indicate an issue with ADM, the stormand service, the power supply, or the USB expansion uni
Thank you again for your help. I appreciate your advice.
hi
you’re welcome
keep me informed
Sync completed overnight & log reports no restarts during the period.
Volume Info shows RAID1, Status & Data Protections all GOOD (Faulty drives tolerated: 1)
Overview shows Volume is HEALTHY
However, when I try to follow your advice at the stage “Run a complete SMART test on each internal drive after synchronization has finished.” I select “Drive” in the Storage Manager → “Drive” but the process hangs without resolving. Therefore I cannot access S.M.A.R.T Info or Disk Doctor. Storage Manager does not respond, so it has to be ended by using the taskbar at the top of the window.
Is this a new problem or could the disk(s) be faulty and possibly caused the restart problem?
I have not yet “used” the NAS to transfer files, or even read them. I have only followed your recommendations & not done any other tasks.
Hi Everyone: I’m still struggling with this problem.
From interrogating the system log, it seems that this specific event is causing the NAS to keep rebooting:
(Certificate Manager): Authentication for lpnasxxxxx.myasustor.com failed
7 seconds pass, then
(Regional options): Successfully synced from the NPT server
4, 5, 6 seconds later (it varies)
System starts & says it did not shut down properly.
I seem to recall that the myasustor.com thing was something I set up years ago to allow remote access to the NAS in order to use Plex services. This turned out to be in the top 5 worst decisions of my life because I was a victim of the Deadbolt ransomware in about 2021. After that the NAS just mouldered away unused for about 3 years until I finally sought assistance from Asustor & rebuilt the system, without (unsurprisingly) remote access.
So, how can I fix this please?
TIA, as always ![]()
Hi,
I don’t think the Certificate Manager authentication failure is necessarily responsible for the NAS rebooting.
The error concerning lpnas7004t.myasustor.com probably indicates that ADM is still trying to authenticate or renew a certificate associated with your old DDNS configuration.
Since you no longer use remote access, I would suggest the following:
- Go to Settings → Manual Connect → DDNS and disable DDNS if it is still enabled.
- Go to Settings → Certificate Manager and check whether an old Let’s Encrypt certificate is associated with your myasustor.com domain. If it is no longer needed, disable automatic renewal or replace it before removing it.
- Check that EZ-Router and any port forwarding rules are disabled if you no longer require external access.
- Monitor the NAS to see whether the unexpected reboots continue.
However, there is something important to consider: the Certificate Manager error and NTP synchronization message may simply be the last events recorded before the NAS crashes. This does not necessarily mean they caused the reboot.
Since you previously mentioned that the NAS continued rebooting even after disconnecting the AS6004U expansion unit, and that Storage Manager sometimes became unresponsive when accessing SMART information, I would not rule out a hardware or ADM-related problem.
I would also check the power supply and system logs.
If the NAS continues rebooting after disabling the unused DDNS and certificate renewal settings, I recommend opening an ASUSTOR support ticket and providing the diagnostic logs.
One question: Does the NAS reboot at approximately the same interval every time, or is it completely random?
This could help determine whether we are dealing with a scheduled service, an ADM issue, or a hardware problem.